Code Search

Please fill the "Code Box" to find engine fault code.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

Other Mitsubishi Cars:

Mitsubishi Sapporo C1208 Engine Trouble Code

Theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

Mitsubishi Sapporo C1208 Code Meaning :

C	1	2	0	8
OBD-II Diagnostic Chassis (C) Trouble Code For Engine	Fuel And Air Metering	Manifold Absolute Pressure/Barometric Pressure Circuit High Input	Cold Start Injector 1 Malfunction	Clutch Position Sensor Circuit Malfunction

When you check Mitsubishi Sapporo car engine light came on code C1208 the reason should be . However manufacturer may have a different definition for the C1208 OBD-II Diagnostic Chassis (C) Trouble Code. So you should chech it on our car models.

C1208 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for C1208 code is occuring now you should check C1208 repair processes.
Now don't ask yourself; What should you do with C1208 code ?
The solution is here :

Mitsubishi Sapporo C1208 Possible Solution :

Disconnected, dirty or fouled spark plugs are common causes for engines that won't start. Spark plugs typically need to be replaced every season or 25 hours of use. You should also check that the spark plug gap is set properly. If your spark plugs look good, problems with your ignition system can also preventing a spark. These can range from a faulty spark plug lead, shorted kill switch or flywheel key damage.

C1208 OBD-II Diagnostic Chassis (C) Trouble Code Description

C1208 engine trouble code is about Clutch Position Sensor Circuit Malfunction.

Reason For C1208 Code

The reason of C1208 OBD-II Engine Trouble Code is Manifold Absolute Pressure/Barometric Pressure Circuit High Input.

Parts or components should not be replaced with reference to only a C1208 DTC. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing.

	Example: 0120